Error Messages And Alerts - Furuno FELCOM 12 Operator's Manual

Error Messages and Alerts

AP-12
A file by that name already exists on FD.
Cannot use this LES. Please check network configuration.
Cannot abort current process.
Cannot activate distress alert test.
Cannot enter this message to sending Queue.
Cannot start PV Test. (not Logged-in)
Cannot start to send. (EGC Receiver)
Cannot start to send. (not Logged-in)
Close a file in use to make a new file.
Communication Unit is not Idle now. Cannot start login.
Communication unit is not Idle now. Cannot start scan.
Communication Unit is not Idle now. Cannot start logout.
This message appears when you attempt
to copy a file from the internal memory to
a floppy disk and a file by that name al-
ready exists on the disk.
You input an invalid LES ID.
The terminal unit displays this message if
you try to stop the DCE in operating con-
dition other than sending, receiving or
scanning.
Distress alert testing cannot be done with-
out permission from LES.
This message appears when a message is
sent to the message queue and it is full (two
messages maximum).
You cannot start PV testing without first
logging in.
Transmission is not possible when the
FELCOM 12 operates as a EGC-only re-
ceiver.
A message cannot be transmitted without
first logging in.
The working areas are full (capacity: two
files). Close a file to load a file to a work-
ing area.
Cannot login when the communication
unit is not idle.
This message appears when the FELCOM
12 operates as a EGC-only receiver and
scanning is initiated when the communi-
cation unit is not idle. Wait until the unit is
idle before starting scanning.
Cannot logout when communication unit
is not idle.