Other Functions; Aborting An Operation - Furuno FELCOM 12 Operator's Manual

Aborting an Operation

This chapter describes how to abort operation, scan NCS and select
EGC and NCS channels.
You can abort transmission, receiving or scanning during operation.
1. Press [F7] to display the Options menu.
Note: If the FELCOM 12 is set to operate as an EGC-only re-
ceiver, the menu looks like this:
Figure 7-2 Options menu, EGC-only receiver status
2. Press [3] to select Abort.
Options
1. Login
2. Logout
3. Abort
4. Select NCS
5. Ocean Region
6. Test
3. Press [Enter] to abort. (The message "Forced Clearing" replaces
either Sending, Receiving or Scanning at the bottom of the screen.)
Note: Aborting is possible in sending, receiving or scanning. If
attempted in other operating modes "Cannot abort cur-
rent process." appears.

OTHER FUNCTIONS

Options
1. Login
2. Logout
3. Abort
4. Select NCS
5. Ocean Region
6. Test
Figure 7-1 Options menu
Options
1. Login
2. Logout
3. Abort
4. Select EGC Ch.
5. Test
Abort
Figure 7-3 Abort screen
Start
Yes No
7-1