Furuno FELCOM 12 Operator's Manual page 120

5-2
2. Press [Enter] or [1] to display Data Report screen.
3. Press [1], [2], [3] or [4] to set addressee desired.
You can set four addressees.
The cursor is on the Status line and "OFF" is selected.
Position Reports
Data Report
1. Data Report
2. Message Reports
Data Report Programming
3. Data Network ID
Status
Report Length
Destination
DNID
LES ID
Member No.
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Figure 5-2 Data report menu
4. Press [Enter] to open the selection window.
5. Select "ON" or "OFF".
ON: Data report on
OFF: Data report off
6. Press [Enter] to close the selection window.
7. Press [ ] to advance the cursor to the Report Length line.
8. Press [Enter] to open the selection window.
9. Select "1" or "2".
1: Position
2: Position, speed, bearing, depth
3: Spare (not used)
10. Press [Enter] to close the selection window.
11. Press [ ] to advance the cursor to the Destination line.
12. Press [Enter] to display the DNID list.
13. Select DNID.
(LES ID and Member ID are automatically selected with DNID.)
14. Press [Enter] to close the DNID list.
Note: If the item "Activation" below is set to "Daily", do the
following steps:
1)Press [ ] several times to select Report Times.
2)Press the [Enter] key to show the screen for entry of trans
mission quantity.
3)Press the [0] key or [Backspace] key to set No Limit.
4)Press the [Enter] key to close the screen.
15. Press [ ] to advance the cursor to the Activation line.
OFF
2
Daily is selected
Regular Interval
00:10
1 (- - - : No Limit)
- - : - -
- - : - -
- - : - -
- - : - -
Regular Interval/Daily
Start Time1 - - : - -
Start Time2 - - : - -
Start Time3 - - : - -
Start Time4 - - : - -