Furuno FELCOM 12 Operator's Manual page 51

5. Press [Enter] to close the position window.
6. Press [ ] to send the cursor to the Navarea line.
7. Press [Enter] to open the Navarea window.
Setup
Receive EGC Area
Additional Position
Navarea
Fixed Area
Waypoint (from NAV Equipment)
NAVTEX
Station Code
Type of Message (Can't reject other report)
Ice reports
Meteo. forecasts
Pilot service
DECCA messages
LORAN messages
Figure 2-22 EGC setup screen, Navarea window
8. Enter additional Navarea(s) (up to nine) for which you want to
receive broadcasts. Figure 2-23 shows the Navareas of the world.
Referring to the figure below for numeral and alphabet, enter ad-
ditional Navareas (up to nine) for which you want to receive broad-
casts.
9. Press [Enter] to close the Navarea window.
10. Press [ ] to send the cursor to Fixed Area.
11. This line is where you enter fixed areas (max. 3) for chart correc-
tion service. However, this service is not yet available; enter no
data.
12. Press [ ] to send the cursor to the Waypoint line.
EGC Setup
:
OFF
OFF OMEGA messages
OFF SATNAV messages
OFF Other navaid msg
OFF QRU (no message)
OFF
Figure 2-23 Navareas
:
OFF
OFF
OFF
OFF
2-13