Replacing The Paper Cutter; Removing The Old Cutter - Epson STYLUS 7890 User Manual

Note: If the optional
SpectroProofer is
attached to the printer,
remove it following the
instructions that came
with it.
Maintaining and Transporting the Printer
To run a super strong cleaning cycle, press d to highlight
•
SS CLEANING
start the cleaning cycle.
To return all control panel settings to their default values, press d to
•
highlight
DEFAULT PANEL
Press to restore the default settings.
OK
4. To exit maintenance mode, turn off the printer by pressing the P Power
button. Press the P Power button again to turn on the printer in the
normal operating mode.

Replacing the Paper Cutter

If you notice that your paper isn't being cut cleanly, the cutter may need to
be replaced.
You can obtain a new cutter from Epson (part number C12C815331). See
page 12 for ordering details.

Removing the Old Cutter

Make sure the printer is turned on, then follow these steps to remove the
cutter:
1. Press r .
Menu
2. Press d until
MAINTENANCE
3. Press d until
CUTTER REPLACEMENT
again.
4. Press . The paper cutter moves to the replacement position.
OK
159
, then press r to display
, then press r to display
is highlighted, then press r
is highlighted, then press r
|
. Press
EXECUTE OK
EXECUTE.
.
159
to