Advertisement
Available languages
Available languages
Donotattempt to service a tire unless youhavetheproper
equipment andexperience t o perform thejob. Ifyouarenot
qualified t o maketherepairs, taketheunitto yourAriens
dealer o r a qualified repair service.
Whenseating tirebeads ontherims,neverexceed 2,4 bar
(35p.s.i.)orthe maximum inflation specified onyourtires.
Inflation beyond thismaximum pressure maybreak the
bead, o r eventherim,withdangerous e xplosive f orce.
Replacement
Parts
Where replacement parts are necessary for periodic
maintenance and servicing, genuine Ariens replacements
must be used.
Ariens does not claim responsibility for installation of
unapproved parts and/or accessories or damages as a
result of their use.
TRANSPORTING
Disengage power to the attachments when in transport or
not in use.
Do not tow this machine. Use a truck or trailer to transport on
public roads.
Do not use this machine on public roads.
WARNING: AVOID INJURY! Read and
understand entire Safety Section before
proceeding.
UNPACK
UNIT
Remove all packing materials and hardware and literature
packages. Discard J hook used with strapping as it is not
needed for mower operation.
SETUP INSTRUCTIONS
Ariens mowers are shipped partially assembled. After
uncrating the power unit and mower deck, initial setup is
required.
IMPORTANT: During the unpacking of the crate all goods
should be matched against the packing list and all shortages
or damages should be noted and reported to the carrier
immediately.
Steering
Controls
1. The steering control levers have been lowered for
shipping. Remove the loose 3/8-16 x 1.50" bolts from
the handles and reinstall them in the location shown.
Adjust the handles to fit your comfort area.
Install bolt here.
Figure 3
Seat Setup
1. Remove the 5/16" flat washers and lock nuts from the
four studs protruding from the bottom of the seat.
2. Route the seat switch connector through the opening
the in the seat plate and plug the connector into the
seat switch.
,
Install the seat on the seat plate with the 5/16" flat
washers and lock nuts removed in step 1. Secure the
p-clip on the wiring harness to the left front seat stud
so the harness gets routed as shown in Figure 4.
Plug harness into
seat switch.
Bottom
P-Clip
S_at Plate
Figure 4
Battery
The battery supplied with the mower is sealed, it will not be
necessary to activate it.
1. Connect the red positive cable to the positive (+) side
of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut. Cover
terminal with rubber boot.
2. Connect the black negative cable to Negative ( - ) side
of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut.
If the engine does not turn over by turning the ignition
switch, it may be necessary to charge the battery, see
Charging the Battery on page 22.
GB - 9
Advertisement
