Ariens 991800-ProZoom 2352S Owner's/Operator's Manual page 23

Figure15
,
,
If adjustment is needed, loosen the nut against the
yoke (3) and while applying slight rearward pressure
on the motion control lever, turn the head of the
adjustment bolt (4) in the appropriate direction until the
lever is centered.
Move the control lever reward and release the control
lever. This control lever should return to a position
where the control lever can be swung outward and lock
in the neutral outward position.
Figure 16 OM5075
STEERING CONTROL LEVER ADJUSTMENT
When the unit is in motion and one steering lever is more
forward than the other when driving in a straight line, the
steering control levers are out of adjustment. Loosen the
hardware on the handlebars and align the pieces. Tighten
the hardware to hold the adjustment. See Figure 17.
NOTE: The steering control levers need to be even in both
neutral or park.
NEUTRAL ADJUSTMENT
,
2.
3.
See Figure 16.
Before making any adjustments, be sure to check the tire air
pressure. Incorrect air pressure can cause the unit to pull to
one side. The correct air pressure is 20 p.s.i, in the front
wheels and 12 p.s.i, in the rear.
Stop the engine and remove the ignition key.
Tilt the seat forward.
,
Move the control lever rearward and release the
control lever. This control lever should return to a
position where the control lever can be swung outward
and lock in the neutral outward position.
If adjustment is needed, move the control lever back to
the inward position and begin to pull rearward. At this
beginning rearward motion the clevis pin should begin
to contact the end of the slot (1) and start putting
pressure on the spring (2).
Adjust handlebars
here.
Figure 17 OM5005
GB - 23