Scanning
2.6
Sending data in an e-mail message (Scan to E-Mail)
Scan to E-Mail
The Scan to E-Mail operation is used to send scan data to a specified e-mail
address as a file attachment.
Recipients can be selected from destinations registered in the address book
or they can be typed in directly. The methods can be combined, for example,
by selecting a recipient from a group destination, then adding other destina-
tions through direct input. Destinations can be selected using any of the fol-
lowing methods. For details, refer to the corresponding section.
Selection method
Selecting from the address book
Entering addresses directly
Selecting a group destination
Selecting a destination that was searched for
Searching for an LDAP server address
Selecting a destination from the address book
Follow the procedure described below to send data by selecting a recipient
from the already registered destinations.
For details on registering destinations, refer to "Registering an address book
destination" on page 3-10.
1
Press the [Fax/Scan] key
in the control panel.
The Fax/Scan mode
screen appears.
C451
2
Page reference
p. 2-36
p. 2-41
p. 2-38
p. 2-43
p. 2-47
2-36