Selecting A Group Destination - Konica Minolta bizhub C451 User Manual

Scanning
4
Touch [Scan Settings], [Original Settings] or [Communication Settings],
and then specify the desired scan settings.
– For details on the scan settings, refer to "Specifying scan and
transmission settings (Scan Settings/Original Settings/Communi-
cation Settings)" on page 2-75.
5
Load the document into the ADF or place it on the original glass.
6
If desired, press the [Proof Copy] key to check a preview image.
– For details, refer to "Sending after previewing" on page 2-20.
7
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
Note
Do not turn off the machine until the scan job is deleted from the Job List
screen.

Selecting a group destination

"Group" refers to multiple destinations that are registered collectively. The
description below describes the procedure for specifying the group and
sending the data, starting from the situation where "Address Book default"
has been set to "Address Type" in [Custom Display Settings] in the User Set-
tings screen.
For details on registering group destinations, refer to "Registering a group
destination" on page 3-32.
!
Detail
For details on screen display, refer to "Default Address Book" on
page 3-47.
C451
2
2-38