E-Mail Tx (Smtp) - Konica Minolta bizhub C451 User Manual

Network Settings
4.9

E-Mail TX (SMTP)

Information, such as the SMTP server, that is required to send data as an e-
mail attachment in Scan mode can be specified. In addition, authentication
settings can be specified for e-mail transmission. Settings can be specified
for the following.
!
Detail
For sending e-mail, administrator address must be specified on this ma-
chine. For details on the administrator address setting, refer to the User's
Guide [Copy Operations].
E-Mail TX (SMTP) screen 1/5
Parameter
Scanning
Status Notification
Total Counter Notification
E-Mail TX (SMTP) screen 2/5
Parameter
SMTP Server Address
E-Mail TX (SMTP) screen 3/5
Parameter
Binary Division
Divided Mail Size
Note
It may not be possible to read the e-mail messages if the e-mail software
used to receive e-mail is not equipped with a restoring function.
C451
Description
Select whether or not Scan to E-Mail operations are used.
Select whether or not status notification is used.
Select whether or not total counter notification is used.
Description
Specify the address of the SMTP server used to send e-mail mes-
sages. For details, refer to "SMTP Server Address" on page 4-79.
Description
Specify whether or not a large e-mail message is divided and sent
in small sections. This is used to send data that has exceeded the
maximum capacity when the maximum capacity is limited per e-
mail message on the e-mail server.
Specify the size of divided data when dividing the data to be sent.
To change the setting, press the [C] (clear) key, and then use the
keypad to type in the desired setting. (Range: 100 to 15000 KB)
4
4-74