Konica Minolta bizhub C451 User Manual page 81
Network scanner operations
Hide thumbs
Also See for bizhub C451:
- User manual (808 pages) ,
- Copy operations (610 pages) ,
- Operation manual (304 pages)
Table of Contents
Advertisement
Scanning
3
Type in the address of the destination, and then touch [OK].
–
To specify additional destinations, repeat steps 2 and 3.
–
Frequently entered user names and domain names can be regis-
tered to be recalled and used again. First, prefixes and suffixes
must be registered in Administrator mode.
The entered addresses appear under "Broadcast Destinations".
4
Touch [Scan Settings], [Original Settings] or [Communication Settings],
and then specify the desired scan settings.
–
For details on the scan settings, refer to "Specifying scan and
transmission settings (Scan Settings/Original Settings/Communi-
cation Settings)" on page 2-75.
5
Load the document into the ADF or place it on the original glass.
6
If desired, press the [Proof Copy] key to check a preview image.
–
For details, refer to "Sending after previewing" on page 2-20.
7
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
Note
Do not turn off the machine until the scan job is deleted from the Job List
screen.
C451
2
2-42
Advertisement
Table of Contents
Troubleshooting
