Chapter 3
3) As you remove the bosses on both sides [1], lower
the front part of the power supply assembly [2].
Then pull it to remove the power supply assembly.
[2]
[1]
F-3-180
3.5.2.13 Removing the Cassette
Pickup Solenoid
1) Place the main unit down on its front face (so that
the interior of the main unit is easily visible).
2) Remove the connector [1] on the ECNT board and
take out the cable from the cable guide.
3) Remove the screw [2] to remove the cassette pickup
solenoid [3], which is located behind the main
motor.
[3]
[2]
F-3-181
3.5.3 Cassette Separation Pad
3.5.3.1 Removing the Rear of
the Cassette
1) Lift the rear of the cassette, and separate the rear
from the front.
3-46
0007-7833
[1]
0002-3783
3.5.3.2 Removing the Cassette
Separation Pad
1) Remove the shafts [1] on both sides of the lifting
plate. Remove the lifting plate [3] while watching
the lifting plate spring [2] carefully.
[3]
[2]
[1]
F-3-182
2) Remove the 2 claws [1] on both sides of the cassette
separation pad and lift it up while watching the
lifting plate spring [2] carefully. Ensure that the
separation pad spring does not get lost.
3) Remove both the plate and the cassette separation
pad [3] by sliding them to the left.
[2]
[1]
F-3-183
0007-7881
[3]