Removing The; Removing The Rear Cover; Removing The Power Supply Shield Plate; Removing The Scanner Unit - Canon MF3110 - ImageCLASS Laser Multifunction Service Manual

3.1.12.4 Removing the front
cover
1) Open the front cover [1] and remove the arm claws
[2] to disengage the connection.
2) Remove the shafts on both sides [3] while warping
the shaft arms inside, and remove the front cover.
[3]
[1]
F-3-83
3.1.12.5 Removing the rear
cover
1) Opening the face up cover [1], and then lower the
fixing pressure release levers [2] on both sides and
release the pressure.
2) Remove 2 screws [3].
3) Remove the rear cover [4] as you pull it toward you.
[2]
[3]
[1]
F-3-84
0007-7556
[3]
[2]
0007-7557
[3]
[4]
3.1.12.6 Removing the Power
Supply Shield Plate
1) Remove the 9 screws [1] to remove the power
supply shield plate [2].
[2]
[1] [1]
F-3-85
3.1.12.7 Removing the Scanner
Unit
1) Remove the connector [1] and the flat cable [2] on
the ECNT board, and remove the screw [3].
(Remove the flat cable from the core.)
2) Remove the 2 screws [4] and the 2 pins [5] on the
right and left sides.
[4]
[1] [3]
F-3-86
Chapter 3
0007-7560
[1]
0007-7561
[5]
[2]
3-21