Table of Contents
Advertisement
4
Enter the entire PlusCode number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the PlusCode number.
If you make a mistake, you can clear it with CLEAR .
Using SELECT , select from the following options:
: Repeated daily recordings from Monday to Friday.
: Repeated weekly recordings (every week on the same day).
5
Confirm with OK .
a
b The programme number of the TV channel has not yet been assigned to
the PlusCode number. Using C and D or the number buttons 0..9 on
the remote control, select the corresponding programme number (name) of
the TV channel and confirm with OK .
a
b The PlusCode number entered is incorrect. Correct your entry or cancel
using the SYSTEM-MENU button.
b Check the time/date see 'Setting the time and date' in 'Installing your DVD
recorder'.
a
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
6
The decoded information appears after confirmation. You can go back
at any time to change the information. Select the appropriate input
field using D or C . If required, change the information using A ,
B or the number buttons 0..9 .
' input field using C . Using SELECT switch on 'VPS/PDC'
Select the '
(' ' lights up). If you press SELECT again, you will switch 'VPS/PDC' off
(' ' disappears).
' input field using C . Using SELECT , select the recording
Select the '
mode '
,
,
7
If all the information is correct, press the
programming information is stored in a TIMER block.
8
To end, press TIMER .
9
Load a DVD (unprotected) ready for recording.
The current disc is checked.
,
'.
Programming a recording (TIMER)
OK button. The
Advertisement
Table of Contents
