Table of Contents
Advertisement
Connecting the DVD recorder
a
Normally, the date and time are transferred from the data of the TV
channel that is stored under programme P01. If the aerial signal is too weak
or disrupted, you must manually set the time and date:
1
Check if the time in line '
2
If required, change the time with the number buttons 0..9 on your
remote control.
3
Select the next line with A or B .
4
Check the displayed settings for: '
5
When all information is correct, save by pressing OK .
a
Not all the necessary data has been transferred. Please enter the settings
by hand as follows. For more information on the various functions see
'Initial installation' in 'Installing your DVD recorder'.
1
Select the desired audio language using B or A and confirm with OK .
2
Select the desired subtitle language with B or A and confirm with
OK .
3
Select the desired picture format using B or A .
'
'
'
'
'
'
For a 16:9 TV set
4
Confirm with OK .
5
Select your country with B or A .
If your country does not appear, select '
6
Confirm with OK .
Initial installation is now complete.
Have the following cables ready:
an aerial cable (1, supplied), a mains cable (2, supplied), a scart cable (3).
1
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA socket at the back of the DVD recorder.
' is correct.
', '
' and '
For a 4:3 TV set; cinema format (black bars above and
below the picture)
For a 4:3 TV set; full height format with the sides cut
off
'.
'.
Advertisement
Table of Contents
