Table of Contents
Advertisement
Your DVD recorder can exchange information with your TV set using 'Easy Link'. Your TV
channels can also be transferred in the same order from your TV set to your DVD recorder
using 'Easy Link'.
Have the following cables ready:
an aerial cable (1, supplied), a mains cable (2, supplied), a special (full) scart cable (3, suitable for
Easylink).
1
Switch off your TV set.
2
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA socket at the back of the DVD recorder.
3
Insert one end of the supplied aerial cable into the TV socket at the
back of the DVD recorder and the other end into the aerial input
socket at the back of the TV set.
4
Plug a special (full) scart cable (for Easylink) into the scart socket
EXT 1 TO TV-I/O at the back of the DVD recorder and the
corresponding scart socket at the back of the TV set (see TV set
operating instructions).
5
Switch on the TV set.
6
Insert one end of the supplied mains cable into the mains socket
4MAINS at the back of the DVD recorder and the other end into
the wall socket.
7
A message appears on the screen announcing that the transfer has
started. '
The TV set transfers all stored TV channels, in the same order, to the
DVD recorder.
This may take several minutes.
8
After the data transfer has been completed, the following appears on
the screen: '
' appears on the display during transfer.
'.
Connecting the DVD recorder
Advertisement
Table of Contents
