Table of Contents
Advertisement
Installing your DVD recorder
7
Select the desired screen format position using B or A . These
settings will only be used if you insert a DVD that contains this
information.
'
'
for wide-screen (cinema format) with black borders at the
top and bottom of the screen.
'
'
for a full-height picture with cropped edges.
'
'
for a wide-screen TV set (screen edge ratio 16:9)
8
Confirm with OK .
9
Select your country with B or A .
If your country does not appear, select '
To call up the specific settings for the respective country, you must first install
the country.
0
Confirm with OK .
A
After you connect the aerial (or cable TV, satellite receiver, etc.) to
the DVD recorder, press OK .
'Autoinstall' starts. '
show:
a
b Select channel 1 on the TV set. Can you see the stored TV channel on the
TV set?
If not, check the cable connection from the aerial (aerial socket) to the
DVD recorder and to the TV set.
b Please have patience.
The DVD recorder searches the entire frequency range in order to find
and store the largest possible number of TV channels. It is possible that the
TV channels in your country are broadcast in a higher frequency range. As
soon as this range is reached during the search, the DVD recorder will find
the TV channels.
b If no aerial is connected, complete the basic settings and then, if desired,
start the automatic channel search (see section 'Automatic TV channel
search (Autoinstall)').
B
Wait until all available TV channels have been found. This can take
several minutes.
C
When AUTOINSTALL is complete, '
briefly appear on the TV screen.
À
To end, press SYSTEM-MENU .
The initial installation is now complete.
Check the date and time. Please read 'Setting the time and date' in this chapter.
'.
' will appear on the display. The screen will
' will
Advertisement
Table of Contents
