How To Remove Memory - Lenovo Aptiva Product Manual

Aptiva S Series 1G Product Guide
To install the memory modules, follow these steps:
1. Ensure that the safety precautions stated for removing the side cover and auxiliary fan
assembly have been observed.
2. Holding the memory module by the edges, remove it from its antistatic package.
3. Make sure the clips at either end of the socket are pushed away from the socket.
4. Position the module above the socket. Align the two small notches in the bottom edge of the
module with the keys in the socket.
5. Insert the bottom edge of the module into the socket.
6. When the module is seated, push down on the top edge of the module until the retaining clips
snap into place. Make sure the clips are firmly in place.
7. Reinstall and reconnect any parts you removed or disconnected to reach the memory module
sockets.

How to Remove Memory

To remove a memory module, follow these steps:
1. Ensure that the safety precautions stated for removing the side cover and auxiliary fan
assembly have been observed.
2. Gently spread the retaining clips at each end of the socket. The memory pops out of the
socket.
3. Hold the memory module by the edges, lift it away from the socket, and store it in an antistatic
package.
4. Install a new memory module or a continuity module in the socket from which you removed
the memory module.
5. Reinstall and reconnect any parts you removed or disconnected to reach the memory module
sockets.
72