Installing Internal Options
To install an external-access drive in the lower 3.5" bay:
1. Remove the cover plate from the empty drive bay.
2. Insert the new drive on its mounting rails (lower 3.5" external-access drive bay only).
3. Remove the filler panel from the front cover.
4. Connect any cables required by the drive.
5. Replace the front cover and side cover before operating the system.
Figure 15. Installing an Internal Drive
✏
NOTES
Installing a drive in the bottom 5.25" bay requires removal of the right side panel (seen from the
front of the system). A drive can be installed in this bay with screws through the sides of the
exertnal-access drive bay. As with any additional external-access drive, you must also remove the
cover plates in the front panel of the chassis and in the front cover.
Installing an additional hard drive requires removal and replacement of the hard drive carrrier,
under the external-access drive bay. This can be accomplished without removing the right side
panel.
77