Boot Menu; Table 18. Boot Menu - Lenovo Aptiva Product Manual

Aptiva S Series 1G Product Guide

Boot Menu

This menu is used for setting the boot features and the boot sequence.
Table 18. Boot Menu
Feature
Quiet Boot
Quick Boot
Scan User Flash
Area
After Power Failure
On Modem Ring
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Notes:
1. HDD = Hard Disk Drive
2. ARMD-FDD = ATAPI removable device - floppy disk drive
3. ARMD-HDD = ATAPI removable device - hard disk drive
56
Options

Disabled

Enabled (default)

Disabled

Enabled (default)

Disabled (default)

Enabled

Stays Off

Last State (default)

Power On

Stay Off (default)

Power On

Disabled

1st IDE-HDD (Note 1)

2nd IDE-HDD

3rd IDE-HDD

4th IDE-HDD

Floppy

ARMD-FDD (Note 2)

ARMD-HDD (Note 3)

ATAPI CDROM

SCSI

Network
Description
Disabled displays normal POST messages.
Enabled displays OEM logo instead of POST
messages.
Enables the computer to boot without running certain
POST tests.
Enables the BIOS to scan the flash memory for user
binary files that are executed at boot time.
Specifies the mode of operation if an AC/Power loss
occurs.
Power On restores power to the computer.
Stay Off keeps the power off until the power button is
pressed.
Last State restores the previous power state before
power loss occurred.
In APM mode only, specifies how the computer
responds to an incoming call on an installed modem
when the power is off.
Specifies the boot sequence from the available
devices. To specify boot sequence:
1. Select the boot device with <
2. Press <Enter> to set the selection as the intended
boot device.
The operating system assigns a drive letter to each
boot device in the order listed. Changing the order of
the devices changes the drive lettering.
Not all of the devices in this list are available as
second, third, and fourth boot devices. The default
settings for the first through fourth boot devices are,
respectively:

Floppy

1st IDE-HDD

ATAPI CDROM

Disabled
 
> or < >.