Searching An Input Signal; Selecting An Aspect Ratio - Hitachi CP-X4020 Operating Manual

Searching an input signal

Press the SEARCH button on the remote control.
1.
The projector will start to check its input ports as below in
order to fi nd any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
COMPUTER IN 1
VIDEO
While the ON is selected for the AUTO SEARCH item in the OPTION menu
42), the projector will keep checking the ports in above order repeatedly till
(
an input signal is detected.

Selecting an aspect ratio

Press the ASPECT button on the remote control.
1.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
For a computer signal
NORMAL
For a video signal, s-video signal or component video
signal
4:3 16:9
For no signal
4:3 (fi xed)
The ASPECT button does not work when no proper signal is inputted.
The NORMAL mode keeps the original aspect ratio setting.
COMPUTER IN 2
S-VIDEO COMPONENT (Y, Cb/Pb, Cr/Pr)
4:3 16:9 16:10
14:9
Operating
SEARCH button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON MUTE
1 2
POSITION MENU
ASPECT button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
17