Hitachi CP-X4020 Operating Manual page 89

Replacing the lamp (continued)
HIGH VOLTAGE
WARNING
lamp can break with a loud bang, or burn out, if jolted or scratched, handled
while hot, or worn over time. Note that each lamp has a different lifetime, and
some may burst or burn out soon after you start using them. In addition, if the
from the projector's vent holes.
About disposal of a lamp: This product contains a mercury lamp; do not put
it in a trash. Dispose of it in accordance with environmental laws.
or www.eiae.org (in the US) or www.epsc.ca (in Canada).
If the lamp should break (it will make a loud bang when it does), unplug the
power cord from the outlet, and make sure to request a replacement lamp
from your local dealer. Note that shards of glass could damage the projector's
internals, or cause injury during handling, so please do not try to clean the
projector or replace the lamp yourself.
Disconnect
If the lamp should break (it will make a loud bang when it does), ventilate the
the plug
from the
power from the projector's vent holes, and not to get them into your eyes or mouth.
outlet
while hot can cause burns, as well as damaging the lamp.
Never unscrew except the appointed (marked by an arrow) screws.
Do not open the lamp cover while the projector is suspended from a ceiling.
This is dangerous, since if the lamp's bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous, so
ask your local dealer to have the lamp replaced even if the bulb is not broken.
Do not use the projector with the lamp cover removed. At the lamp replacing,
damage or injury.
are electrical problems elsewhere besides the lamp. If this happens, consult
your local dealer or a service representative.
Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
Using the lamp for long periods of time, could cause it dark, not to light up or to burst.
When the pictures appear dark, or when the color tone is poor, please replace the
lamp as soon as possible. Do not use old (used) lamps; this is a cause of breakage.
HIGH TEMPERATURE
www.lamprecycle.org (in the US).
13
HIGH PRESSURE
Handling the lamp
Use of a lamp that does not meet the