Hitachi CP-X4020 Operating Manual page 25

Operating
Selecting an input signal (continued)
Press the COMPUTER button on the remote control.
1.
Each time you press the button, the projector switches its
input port from the current port as below.
COMPUTER IN 1
While the ON is selected for the AUTO SEARCH item in
the OPTION menu, the projector will keep checking every
port sequentially till an input signal is detected (
COMPUTER button is pressed when the VIDEO, S-VIDEO
or COMPONENT port is selected, the projector will check the
COMPUTER IN1 port fi rst.
Press the VIDEO button on the remote control.
1.
Each time you press the button, the projector switches its
input port from the current port as below.
COMPONENT (Y, Cb/Pb, Cr/Pr)
While ON is selected for AUTO SEARCH item in OPTION
menu, the projector will keep checking every port sequentially
till an input signal is detected (
pressed when the COMPUTER IN1 or the COMPUTER IN2
port is selected, the projector will check the COMPONENT
port fi rst.
Press the MY SOURCE / DOC. CAMERA button on
1.
the remote control. The input signal will be changed
into the signal you set as the MY SOURCE (
This function also can use for document camera. Select the
input port that connected the document camera.
16
COMPUTER IN 2
S-VIDEO
42). If the VIDEO button is
COMPUTER button
42). If the
VIDEO
MY SOURCE /
DOC. CAMERA button
44).
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH
BLANK
FREEZE PAGE VOLUME
MAGNIFY
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
VIDEO button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
PAGE VOLUME
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
MENU
POSITION
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
FREEZE PAGE VOLUME
MAGNIFY
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU