Output Selector Switch; Meters - Miller Electric SYNCROWAVE 250 Technical Manual

4-2. Output Selector Switch

4-3. Meters

TM-353 Page 14
1
1
1 Output Selector Switch
Y Do not use AC output in
damp areas, if movement is
confined, or if there is dan-
ger of falling. Use AC output
ONLY if required for the
welding process, and then
use a remote control.
Y Do not change position of
switch while welding or
while under load.
Use switch to select (DCEN) Direct
Current Electrode Negative, AC, or
(DCEP) Direct Current Electrode
Positive output without changing
weld output cable connections.
1 Voltmeter
Voltmeter displays voltage at the
2
weld output terminals, but not nec-
essarily the welding arc due to
cable resistance, poor connec-
tions, etc.
2 Ammeter
Ammeter displays weld amperage
output of unit.
Ref. ST-181 675-A
Syncrowave 250