Completing The Table Plate For The Mg 55-3 Stand With Direct Drive - Duerkopp Adler 869 Instruction Manual

3.4

Completing the table plate for the MG 55-3 stand with direct drive

6
(3,5x17) 6x
Top view of table plate
7
(4x20) 2x
5
4
3
–
Turn over the table plate 5.
–
Screw on the cable duct 1.
–
Screw on the motor control 2.
–
Screw on the power supply 3.
–
Screw on the knee switch for the sewing-foot stroke.
(Only for subclasses 869-180322, 869-280322)
–
Screw on the set value initiator 8 (refer to chapter 6.1).
–
Screw on the drawer 6 together with its fixtures.
–
Screw on the sewing light transformer 7 (optional equipment).
–
Mount the electrical cable according to the instructions in
chapter 12.
8
(4x20) 2x
1
(3,5x17) 2x
Marking for stand
2
9
GB