Table of Contents
Advertisement
3.2.2
Assembling the table top with the motor on the machine head (direct drive)
10
8
9
2
4
6
3
5
6
1
10
–
Turn the table top (1) upside down.
–
Screw the electric cable channel (2).
–
Screw the pedal position sensor (3).
–
Screw the electric cable clip (4).
–
Put the oil sump on (5) and slide it in the arrow direction (6) till the
relevant protrusions of the oil sump are seated on the recess
contour. Screw the oil sump.
–
Screw the drawer (7).
–
Pre-bore the holes for wood screws and screw the drive control
box (8).
–
Screw the sewing lamp transformer (9) – if there is any.
–
Mount electric cables according to the instructions in chapter 5.
–
Pre-bore the holes (10). Attach the table plate to the stand with
woodscrews (B8 x 35). Then turn the stand to normal position.
–
Insert the yarn stand (11) in the hole in the table plate and secure
it with the nuts and washers. Fit and align the yarn reel and
unwinding holders.
–
Insert the machine head support pin (12).
–
Place the hinge bottoms (13) for the machine head into the cutout
of the table plate (1) and tighten the screws.
–
Insert the wedges (14) in the recess corners.
–
Insert the rubber cushions (15).
–
Remove the blind from the bushing (16).
–
Remove the knee lever (17) and guide through the opening, as
shown in the illustration.
7
11
15
14
12
13
16
17
Advertisement
Table of Contents
