Completing The Table Top With The Control And Fastening It To The Stand; Self-Manufacture Of The Table Top - Duerkopp Adler 175 Instruction Manual

3.2 Completing the table top with the control and fastening it to the stand

3.3 Self-manufacture of the table top

–
Insert the machine head support 15 into the bore of the table top.
–
Insert the rubber supports 14 for the machine head into the
recesses of the table top 12.
–
Insert rubber corners 13.
–
Screw drawer 11 with its holders underneath the table top on the
left.
–
Screw cable duct 10 underneath the table top at the back.
–
Punch-mark the positions of the screw connections of the oil drip
pan 2 and fasten it with wood screws under the cutout of the table
top.
–
Fasten the table top 12 with wood screws (B8 x 35) on top of the
stand.
The alignment on the stand is specified by the measurements
indicated in the sketch.
–
Insert the yarn stand 1 into the bore of the table top and fasten it
with nuts and washers.
Mount and align yarn stand and thread guiding arm.
The yarn stand and the thread guiding arm must be positioned
vertically on top of each other.
If you manufacture the table top yourself, please take the
measurements from the illustrations on page 18.
GB
5