Table of Contents
Advertisement
3.3
Completing the table plate for the MG 55-3 stand with FIR clutch motor
5
(3,5x17) x2
8
Top view of table plate
6
(4x20) x2
4
–
Turn over the table plate 4.
–
Screw on the cable duct 1.
–
Screw on main switch 2.
–
Screw on the power supply (optional equipment).
–
Screw on the drawer 5 together with its fixtures.
–
Screw on the sewing light transformer (optional equipment).
–
Mount the clutch motor 7.
For this, screw the three hexagon bolts (M8 x 40) with washers into
the anchor nuts on the table plate.
The belt pulley 8 must point to the right when the table plate is
mounted.
–
Mount the electrical cable according to the instructions in
chapter 12.
7
7
3
(4x20) x2
Marking for stand
1
(3,5x17) x2
2
(5x25) x2
4
8
Advertisement
Table of Contents
