Completing The Table Plate - Duerkopp Adler H867 Operating Instructions Manual

Set-up instructions

8.5 Completing the table plate

Making your The table plate belongs to the optional delivery scope. If you want to make
own table plate your own table plate, drawings with the dimensions are available in the
Appendix.
u
y
t
(1) - Thread reel holder
(2) - Hole in the table plate
(3) - Corner projections
(4) - Oil pan
Figure 34: Completing the table plate
• Screw the drawer (5) with the left-hand bracket to the underside of the
• Screw the oil pan (4) in place under the recess for the machine.
• Screw the cable duct (7) to the underside of the table plate.
• Insert the thread reel holder (1) in the hole.
• Fasten the thread reel holder (1) with nut and washer.
• Screw the thread real holder and the unwinding bracket onto the
• Insert the plug (2) in the hole.
• Insert the rubber mounts of the hinge in the recesses (6).
• Insert the rubber corners in the corner protrusions (3) of the recess for
Operating manual H867 Version 00.0 - Last updated: 01/2012
table plate.
thread reel holder (1) in such a way that they are exactly opposite
each other.
the machine.
q
w
e
r
(5) - Drawer
(6) - Recesses for the rubber mounts of
the hinge
(7) - Cable duct
35