3.7.2
MG 56-3 stand
7
8
–
Fasten the table plate 2 to the stand 5 using wood screws (6x30).
Pre-drill the holes for the wood screws.
Be sure to note the marking for the stand (refer to chapters 3.5,
3.6).
–
Fasten the table plate 8 to the latch 7 using three wood screws
(5x30).
–
Attach the rod 6 onto the pedal and the actuating lever 4 (only for
FIR clutch motor).
–
Attach the rod 3 onto the actuating lever 4 and motor.
–
Put the reel stand 1 into the drilled hole in the table plate. Fasten
with nut and washer.
–
Mount and align the reel holder and unwind holder.
These two holders must be positioned on top of each other.
4
5
6
1
2
GB
3
13