Sound Setting; Setting The Mx Mode; Adjusting The Hpf/Lpf - Alpine CDA-W560E Owner's Manual

Sound Setting

AUDIO TUNE
/ / -
Rotary encoder
SOURCE/POWER
-/J / ENT.

Setting the MX Mode

MX (Media Xpander) makes vocals or instruments sound distinct
regardless of the music source. The FM radio, CD, and MP3/WMA,
will be able to reproduce the music clearly even in cars with a lot of
road noise.
1
Press MX to select MX ON.
2
Press SOURCE/POWER to select the source you
want to MX (Media Xpander)-correct.
3
Press and hold MX for at least 2 seconds to select
the MX mode.
4
Turn the Rotary encoder within 15 seconds to
select your preferred mode or OFF.
FM (MX level 1 to 3):
The medium to high frequencies become more clear, and
produces well balanced sound in all the bands.
CD (MX level 1 to 3):
CD mode processes a large quantity of data. This data is
used to reproduce the sound cleanly by making use of the
data quantity.
MP3/WMA (MX level 1 to 3):
This corrects information that was omitted at the time of
compression. This reproduces a well-balanced sound
close to the original.
DVD (Video CD) (MX level 1 to 2):
The dialogue portion of the video is reproduced more
clearly.
DVD (CD) (MX level 1):
This disk contains a large quantity of data such as music
clip. MX uses this data to reproduce the sound accurately.
AUX (MX level 1):
Choose the MX mode (MP3, MUSIC, or MOVIE) that
corresponds to the media connected.
20
-EN
5
After setting, press the Rotary encoder to return
to the normal mode.
• To cancel MX mode for all music sources, press the MX button to
turn MX OFF in Step 1.
• MX mode is automatically cancelled if no buttons are pressed
within 15 seconds.
• Each music source, such as radio, CD, and MP3/WMA can have its
own MX setting.
• On disks with both MP3/WMA and CD-DA, when the source
changes from "MP3/WMA to CD-DA" or "CD-DA to MP3/
WMA", the MX-mode switching process may take a little time
before a piece is played due to.
• This function is inoperable when DEFEAT is ON (See Page 5).

Adjusting the HPF/LPF

The High and Low Pass Filters on this unit can be adjusted to suit
your personal taste.
1
Press AUDIO TUNE.
2
Press / or - within 15 seconds, select HPF or
LPF adjustment mode, and then press -/J / ENT.
to set.
B-FOCUS
T-CORR
(BSF) (TCR)
EQ LPF
HPF
• The LPF function is only available when the subwoofer output
from this unit is set to ON.
3
Press / or - within 15 seconds, select the
frequency, and press -/J / ENT..
1. HPF (Setting the High Pass Filter):
FLAT (OFF) ↔ 80Hz ↔ 120Hz ↔ 160Hz
Outputs all frequencies higher than that selected according to
your preference.
2. LPF (Setting the Low Pass Filter):
FLAT (OFF) ↔ 80Hz ↔ 120Hz ↔ 160Hz
Outputs all frequencies lower than that selected according to
your preference.
(Only available when using the subwoofer output from this
unit.)
4
After completing the setting, press AUDIO TUNE
to return to the normal mode.
• If no buttons are pressed within 15 seconds, the bass engine menu
returns to the normal mode.
• Except when the HPF and LPF is turned OFF, the subwoofer is in
monaural mode.