Time Correction Adjustment And Storage/Calling - Alpine CDA-W560E Owner's Manual

Time Difference Table
Time
Number of Number of
Difference
Steps Steps
(ms)
0 0.0 14
1 0.1 15
2 0.2 16
3 0.3 17
4 0.4 18
5 0.5 19
6 0.6 20
7 0.7 21
8 0.8 22
9 0.9 23
10 1.0 24
11 1.1 25
12 1.2 26
13 1.3 27
Time Correction Adjustment and Storage/
Calling
Before performing the following procedures, refer to "About the Time
Correction" (page 22).
1
Press AUDIO TUNE.
2
Press / or - within 15 seconds, select the time
correction adjustment mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
B-FOCUS
T-CORR
(BSF)
(TCR)
EQ LPF HPF
3
Press / or - within 15 seconds, select the
ADJUST mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
4
Press / or - within 15 seconds to adjust the time
correction value (0.0 to 9.9) of the first speaker
(F-L), then press -/J / ENT. to set.
24
-EN
Time Time
Number of
Difference Difference
Steps
(ms) (ms)
1.4 28 2.8
1.5 29 2.9
1.6 30 3.0
1.7 31 3.1
1.8 32 3.2
1.9 33 3.3
2.0 34 3.4
2.1 35 3.5
2.2 36 3.6
2.3 37 3.7
2.4 38 3.8
2.5 39 3.9
2.6 40 - 98 4.0 - 9.8
2.7 99 9.9
5
Repeat Step 4 and set another speaker.
F-L F-R R-L
6
When finished with the settings, press / or -,
select EXIT, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
• Selection of CONTINUE will cause a return to the time
correction adjustment mode.
• Selection of P-MEMORY will set the storage mode of the
adjustment value. (See "Storing the Adjustment
Contents".)
7
Press AUDIO TUNE to return to the normal mode.
• The adjustment value in the time correction adjustment is also
reflected in the Bass Focus mode.
Storing the Adjustment Contents
1
Following Step 6 mentioned on the left within 15
seconds, press / or - to select P-MEMORY, then
press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
2
Press / or - within 15 seconds, select one of
"PRESET 1" to "PRESET 6," and press -/J / ENT..
This will store the adjusted contents in the selected
PRESET number.
3
Press AUDIO TUNE to return to the normal mode.
• The contents stored in presets 1 to 6 will be maintained even when
the unit is reset or the battery power cable is disconnected.
Calling the Stored Time Correction Value
1
Following Step 3 mentioned on the left, press / or
-, select the SELECT mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
2
Press / or - within 15 seconds, select one of
"PRESET 1" to "PRESET 6," and press -/J / ENT..
This will call the stored adjustment contents.
R-R