Quick Search; Playing Mp3/Wma Data; Scanning Programmes - Alpine CDA-W560E Owner's Manual

Quick Search

You can search for tracks (files).
Press and hold or
track (file number).
The selected track is played back immediately.
• Holding down or
continuously and removing your finger starts playing that track.
MP3/WMA Play Display
The folder number, file number, sampling rate, and bit rate
will be displayed as described below.
Folder number display
01 03
44.1
kHZ
Sampling rate display
The sampling rate and the bit rate
(frame display) are alternately
displayed.
Folder number display
01 03
160
kbps
Bit rate display
As the root folder number is displayed as 1, when there is no
file in the root folder, the first folder is displayed as 2 and
played back.
• Press TITLE to switch the display. Please see "Displaying the
Title/Text" (on Page 18) for information about display switching.
10
-EN
to select the desired
causes the files to change
File number display
File number display

Playing MP3/WMA Data

This product can playback CDs containing both CD and MP3/WMA
data. However, in some situations (some enhanced CDs), playback
may be difficult. For these special cases, you can select playback of
CD data only. When a disc contains both CD or the MP3/WMA data,
playback starts from the CD data portion of the disc.
1
Press FUNCTION/SETUP to select the SETUP
mode*.
* See "About SETUP" on Page 6.
2
Press / or - to select the CD-DA mode.
3
Press -/J / ENT. to set the disc selection range.
CD-DA ONLY CD-DA & MP3/WMA
(Initial setting)
4
After completing the setting, press FUNCTION/
SETUP to return to the normal mode.
• Perform this setting before inserting a disc. If a disc has already
been inserted, perform the setting after you remove the disc. (If you
use an MP3 changer, you have to change discs.)

Scanning Programmes

The first 10 seconds of each track (file) will be played back in
succession.
1
Press FUNCTION/SETUP to select the FUNCTION
mode.
FUNCTION
mode
2
Press / or - to select the SCAN mode, then press
-/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
3
Press / or - to select ON, then press -/J / ENT..
ON OFF
• When you have found a desired track for listening, switch the
function OFF with the above procedure.
• The FUNCTION mode will be cancelled when an operation has
not been performed in 10 seconds.
SETUP NORMAL
mode mode