Removal Of The Spark Plug; Idle Setting; Transmission - PEUGEOT Tweet Workshop Manual

Removal of the spark plug

- The engine must be cold.
- Remove the battery access door (5 screw).
- Disconnect the suppressor (1).
- Remove the spark plug.
Tightening torque: 12 Nm.
- Recommended spark plug:
• 50 cc: NGK CR6HSA.
• 125/151 cc: NGK CR7HSA.
• Electrode gap: 0.7 to 0.8 mm.
Essential precautions:
installing, srew in the spark plug (a few
turns) by hand.

Idle setting

- The engine must be at its operating
temperature.
- Switch off the engine.
- Check the operating clearance in the throttle.
- Remove the rubber plug .
- Start the engine.
- Screw or unscrew the engine speed adjuster
screw (1) to alter the idle speed.
Idle speed:
50 cc: 2000 to 2200 rpm.
125/151 cc: 1700 to 1900 rpm.

Transmission

- Lift the air filter box to reach the transmission
cover (2 screw).
- Disconnect the transmisson cooling air
intake (1).
- Remove the transmission cover.
• 50 cc: 10 screw
• 125/151 cc: 8 screw
Tightening torque: 10 Nm.
- Remove the paper gasket and the two 2
centering pins.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
When re-
1
SERVICE OPERATIONS
1
27