Installing The Valve Clearance - PEUGEOT Tweet Workshop Manual

SERVICE OPERATIONS

Installing the valve clearance

- Remove the storage compartment. See: Range 1. page 20.
- Remove the battery access door.
- Remove the RH and LH under body panel.
- Remove the under-footboard fairing (4 screw).
- Remove the battery.
- Remove the valve clearance adjustment
covers (1).
Tightening torque: 15 N.
When re-installing, use a new
gasket.
1
- Remove the turbine on the the flywheel
magneto side (4 screw).
- Turn the magnetic wheel to line up the "T"
mark with the the crankcase boss (A).
A
32
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
50 cc
1
T
125/151 cc
- Disconnect the oil vapour return hose to the
rocker cover.
- Remove the pneumatic valve (2).
- Remove the rocker cover. (4 screws and
2 nuts).
Tightening torque: 10 Nm.
When re-installing, use a new
gasket.
2
- Using wrench, turn the crankshaft in the
direction of operation to as to line up the
marks on the camshaft gear (B) with the
cylinder head gasket face.
B