Show Ssl Errors; Table C-3 Output Description For Show Ssl Errors - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Appendix C Command Summary

show ssl errors

Syntax Description
Usage Guidelines
78-13124-05
See the sections "SSL Configuration Command Set", "Certificate Configuration
Command Set", and "Certificate Group Configuration Command Set".
Displays SSL errors reported on the device.
show ssl errors [continuous] [interval <value>]
continuous
interval
value
Availability: Serial, Telnet; FIPS Mode (serial only)
(This command must be given on one line.) Displays SSL errors reported on a
single device or module. Use the continuous keyword to update the statistics
every second. Use the interval keyword to specify an interval for display updates,
where value is the interval in seconds. Press any key to stop displaying errors.
Table C-3 displays output descriptions.
Table C-3 Output Description for show ssl errors
Error
SSL Negotiation Errors
Total SSL Connections Rejected The number of SSL connections rejected
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Displays errors continuously.
Specifies an interval for display updates.
The interval in seconds.
Description
The number of SSL negotiation failures
when the pre-defined limit of connections has
been exceeded
Top Level Command Set
C-29