Keepalive-Intv; Max-Rexmit - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Appendix C
Command Summary
keepalive-intv
Syntax Description
Usage Guidelines
Related Commands
max-rexmit
Syntax Description
78-13124-05
Specifies the interval between keepalives.
keepalive-intv <seconds|default>
no keepalive-intv
seconds
default
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to return the keepalive-intv to the global value.
If no global settings exist for a parameter, the factory default parameter is used
instead. See RFC 1122.
keepalive (TCP Tuning Configuration Command Set)
keepalive-cnt (TCP Tuning Configuration Command Set)
Specifies the number of times an unacknowledged segment is retransmitted.
max-rexmit <count|default>
no max-rexmit
count
default
Cisco 11000 Series Secure Content Accelerator Configuration Guide
The number of number of seconds between
keepalives; the valid range is from 20 to 600
(inclusive).
The factory default. At the time of publication, the
factory default is 30 seconds.
The number of number of keepalives that are sent; the
valid range is from 1 to 65535 (inclusive).
The factory default. At the time of publication, the
factory default is 12.
Configuration Command Set
C-171
Advertisement
Table of Contents
Troubleshooting
