Status Indicators; Displaying Total Number Of Copies - Olivetti Copia 9910 Operation Manual

STATUS INDICATORS

Be sure to use only genuine parts and
supplies.
When the following indicators light up or blink on the operation panel or the following symbols appear in the
display, solve the problem immediately referring to both the table below and the relevant page.
Indication
Drum replacement
required indicator
w
TD cartridge replace-
ment required indicator
s
Misfeed indicator
t
SPF misfeed indicator
The paper tray
indicator is blinking.
„CH" is blinking in
the display.
n
„CH" is steadily lit in the
display.
„P" is blinking in
the display.
Q
A letter and a number
appear alternately.

DISPLAYING TOTAL NUMBER OF COPIES

Use the following procedure to display the total number of copies.
1 – 32
2nd_part_d_gb.p65
Cause and remedy
Steadily
Replacement of drum cartridge will be needed soon. Prepare
lit
a new cartridge. p. 1-23
Blinking
Drum cartridge must be replaced. Replace it with a new one.
p. 1-23
Steadily
Replacement of TD cartridge will be needed soon. Prepare a
lit new cartridge. p. 1-21
Blinking
TD cartridge must be replaced. Replace it with a new one.
p. 1-21
Blinking
A misfeed has occurred. Remove the misfed paper referring to
the description of „Misfeed removal." p. 1-26. Lever of fusing
area is not raised. p. 1-27. Depending on your model, the lower
side cover may be open. If so, close it. p. 1-28.
An original misfeed has occurred in the SPF. Remove the misfed
Blinking
originals referring to the description of "Misfeed in the SPF".
p. 1-29.
The paper tray is not installed properly. Push the tray into the
copier securely. p.1-8.
The TD cartridge is not installed. Check if the cartridge is instal-
led. p. 1-7
Side cover is open. Close the side cover securely by pressing
the round projections near the side cover open button. p. 1-7
Paper tray or bypass tray is empty. Load copy paper. p. 1-8
A misfeed has occurred in the paper tray or bypass tray.
Remove the misfed paper. p. 1-26
Paper tray is not securely installed. Push the tray in securely.
p. 1-8, 1-16
The copier will not function. Turn the power switch off and
then switch it on, and if there is again an error, remove the
power cord from the outlet, and contact your authorized Ser-
vice representative p. 1-4.
>
1. Press the clear ( ) key to reset the
display to zero.
2. Press and hold down the clear (
key for approximately 5 seconds. The
total number of copies will appear in
two steps, each with three digits.
Example:
Total number of copies is 1,234.
32
>
)
24/05/99, 13.23