Group Calling Member Assignments - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Optional Group-Assigned Features

Group Calling Member Assignments

Use this procedure to assign or remove a telephone from a calling group. A
calling group is used to direct calls to a group of people who all handle the
same type of call. A single extension number is assigned to the group and is
used by both inside and outside callers to reach the group.
NOTE:
If a linear hunting pattern is indicated on the back of the form, be sure to
assign telephones to the group in the exact order that they are shown on
the form. The system searches for an available member in the order that
you assign the telephones to the group.
A maximum of 32 calling groups with a maximum of 20 telephones per group
is allowed.
A telephone can belong to only one calling group. A QCC cannot be a
member of a calling group. The delay announcement device should not be
programmed as a calling group member.
The extension status feature must be set to the Calling Group or CMS mode
before you assign members to the group. See "Extension Status" for more
information.
To reassign a telephone to a new calling group, you must remove it from its
old group before programming the new assignment.
Group Calling Member Assignments
13-7