Outmode Signaling For Loop Or Ground Start Trunks - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Lines and Trunks
Outmode Signaling for Loop or
Ground Start Trunks
Use this procedure to identify either touch-tone signaling or rotary dial
signaling for outgoing calls placed by using each loop- or ground-start trunk.
NOTE:
This procedure is not required if your system has only touch-tone
lines/trunks.
Summary: Outmode Signaling for Loop or
Ground Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
† Entry mode available
System manager
Loop Start - All; Ground Start
Not required
Form 2c, System Numbering – Trunk Jacks
Touch-tone
Touch-tone, rotary
No
Yes
†
To program a single extension:
LinesTrunks
entry mode
Exit Exit
To program a block of extensions:
LinesTrunks
block of lines
Exit Exit

Outmode Signaling for Loop or Ground Start Trunks

–
Hybrid/PBX only
TT/LS Disc
Dial no. of the line
TT/LS Disc
Toggle LED On/Off
Exit
Select
Outmode
Enter Exit
Select
OutMode
Enter
4-3