Recall Timer - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

System Features

Recall Timer

Use this procedure to designate the length of the timed flash that is sent when
Recall is used to disconnect a call and get a new dial tone without hanging
up. The interval of the timed flash and how Recall works depend on the type
of telephone and system operating mode.
The Recall Timer should be reset if multiline telephone users experience either
of the following problems:
When the user presses the Recall button on an outside call, nothing
happens. This indicates that the interval is too short and should be
increased to 650 milliseconds or 1 second.
In a system operating in Behind Switch mode, when the user presses
the Recall button on an outside call, the call is disconnected. This
indicates that the interval is too long and should be decreased to 350
milliseconds.
Summary Recall Timer
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
14-22
Recall Timer
System manager
All
Not required
Form 6f, System Features
450 ms
350 ms, 450 ms, 650 ms, 1 second
No
No
More
Options
Select time
Enter
[F7] [PgUp]
[F5]
Select RecallTimer
Exit
[F3] Select time [F10]