AT&T Merlin II Feature Module 2 System Manual page 44

2-38
MERLIN II System Features
With a MERLIN II System Display Console
1 From the administration menu, touch
2 Touch the Auto Intercom button for the voice terminal to be programmed.
3 Touch .
[Enter]
4 If the red light next to Adm Tel goes off and the console rings every 5
seconds, go on to step 4. If not, wait for the light to go off or try again
later.
5 Perform the steps shown in the programming procedure for the feature,
except for entering and leaving programming mode.
6 Touch Conference to return to the administration menu, or leave
administration mode.
With a BIS-34D Console
1 When you see lights flash next to Adm Pool, Adm Tel, Message,
Speaker, indicating that you are in administration mode, touch
Conference.
The red light next Adm Tel goes on.
to
Dial the intercom number for the voice terminal you want to program.
2
The red Adm Tel goes on.
light next to
If the voice terminal you want to program is busy, the red light
NOTE:
next to Adm Tel and the green light next to the Auto Intercom button
flash alternately. You must wait for the voice terminal to become idle
before going on. If you prefer not to wait, you can touch Conference
again and select another voice terminal to program, or touch Conference
twice to stop programming.
When you hear two beeps, you can begin Centralized Programming.
3
Follow the programming procedures described under the individual
features.
4 To program another voice terminal, repeat steps 1 through 3.
Touch Conference twice to go on to another administration procedure or
5
leave administration mode.
.
[More], [More], [CntrPrg]
and