Loudspeaker Paging System; Music Coupler - AT&T Merlin II Feature Module 2 System Manual

Loudspeaker Paging System

Music Coupler

DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
See "Loudspeaker Page"
If your system has the Music-on-Hold feature, you must connect the music
source, such as a tape player, to the MERLIN II system with a music coupler.
The music coupler shown in Figure 2-25 provides a secondary bridged
connection so that the music source can also be connected to a loudspeaker
paging system to provide background music in sections of your building in
which paging speakers are located.
FIGURE 2-25 A music coupler.
paging system
To
(Front view)
You can use a radio, tape player, cassette player, or stereo system as a music
source for the Music-on-Hold feature. For more information about this
feature, see "Music-on-Hold.'' If you need to know the procedures for using
your loudspeaker paging system and the Loudspeaker Page feature, see
"Loudspeaker Page. "
To avoid music distortion, be sure that the output level of the music source
below 10 volts (i.e. approximately 12.5 watts across an 8 OHM speaker).
NOTICE:
Users of equipment that rebroadcast copyrighted music or other
material may be required to obtain a license from a third party such
ASCAP or BMI.
For directions on administering the Music-on-Hold feature for your system,
see "Music-on-Hold. "
in "MERLIN II System Features."
MERLIN II System Features
To line jack
(Back view)
is
as
2-183