AT&T Merlin II Feature Module 2 System Manual page 202

Administration Procedure
Call restrictions and allowed lists
continued):
To assign access to allowed lists to
voice terminals
To get a printout of an allowed list
To get a printout of voice terminal
access to allowed lists
Camp On return interval
Centralized Programming
Dialing Timeout for rotary lines
3-10 Button Code Administration Procedures
1 Touch Message.
2 Dial #4.
3 Dial list number (0 through 7).
4 Touch Auto Intercom button for voice terminal:
Steady green on = voice terminal has access to numbers on list
Green off = voice terminal doesn't have access to numbers on list
5 Touch Message.
1 Touch Message.
2 Dial #5.
3 Dial list number (0 through 7).
4 Dial 0 #900 and wait for beep.
5 Touch Message.
1 Touch Message.
2 Dial #904 and wait for beep.
3 Touch Message.
1 Touch Message.
2 Dial # 326.
3 Dial number of minutes (1 through 5) preferred before calls
return to originator.
4 Touch Message.
1 Touch Conference.
2 Touch Auto Intercom button for voice terminal to be programmed.
3 If red light next to Adm Tel goes off and console rings every 5
seconds, go on to step 4. If not, wait for light to go off or try
again later.
4 Perform programming steps, except for entering and leaving
programming mode.
5 Touch Conference twice.
1 Touch Message.
2 Dial # 317.
3 Dial number to specify timeout interval:
0 = 0 seconds
1 = 4 seconds
2 = 8 seconds
3 = 12 seconds
4 Touch Message.
Do This