Button Code Administration Procedures - AT&T Merlin II Feature Module 2 System Manual

Button Code Administration Procedures

Basic Administration Procedures
Administration Procedure
System size
System type
System Renumbering Procedure
3-2 Button Code Administration Procedures
Button code administration procedures are divided into two categories: basic
and optional procedures.
1 Touch Message.
2 Dial #201.
3 If green light next to Message is steady and you hear two beeps, go
on to step 4. If not, wait for 2-beep signal or try again later.
4 Dial number to designate system size:
o = small system
1 = large system
5 Wait for lights next to Adm Tel, Adm Pool, Message, and Speaker
to flash. At this signal, go to another procedure or leave
administration mode.
1 Touch Message.
2 Dial #202.
3 If green light next to Message is steady and you hear two beeps, go
on to step 4. If not, wait for Z-beep signal or try again later.
4 Dial number to designate system type:
0 = square
1 = pooled with Button Access to Line Pools
2 = pooled with Dial Access to Line Pools
3 = pooled with Automatic Route Selection (ARS)
4 = behind-switch
5 Wait for lights next to Adm Tel, Adm Pool, Message, and Speaker
to flash. At this signal, go to another procedure or leave
administration mode.
1 Touch Message.
2 Dial #299.
If the light next to Message flashes by itself, one or more calls are in
progress and the procedure is not executed–wait for the light to
become steady, then go on to the next step.
3 When the lights next to Adm Tel, Adm Pool, Message, and Speaker
begin to flash, go to another procedure or leave administration
mode,
Do This