8508A
Users Manual
DC Current
The following commands are used to select the
Nrf
A numeric value that selects the range for the expected signal. Any valid numeric value
cancels autorange.
AUTO
Selects the autorange mode where the multimeter will determine the appropriate range for
the measured signal. If the signal exceeds the maximum capability then
OVERLOAD
registers.
FILT_ON / FILT_OFF
FILT_ON
RESL5 / RESL6 / RESL7
Sets the resolution of the measurement to 5.5, 6.5, or 7.5 digits.
FAST_ON / FAST_OFF
FAST_ON
Power On and Reset Conditions
2A, FILT_OFF, RESL7, FAST_ON
4-16
DCI
phs
appears on the front panel and the appropriate bit is set in the device status
inserts a hardware analog filter into the measurement signal path.
Reduces the A-D integration time, for faster conversions.
function and set its configuration.
DCI
,
Nrf
A UTO
FILT_ON
FILT_OFF
RESL5
RESL6
RESL7
FA ST_ON
FA ST_OFF
DC Current
adj215f.eps
RANGE