Resistance: Normal Ohms - Fluke 8508A User Manual

Recall of Spot Frequency Value
(Nr3) Recalls the frequency value for the specified calibrated spot on the active ACV
range.

Resistance: Normal OHMS

The following commands are used to select the Normal
configuration.
Nrf
A numeric value that selects the range for the expected signal. Any valid numeric value
cancels autorange.
AUTO
Selects the autorange mode where the multimeter will determine the appropriate range for
the measured signal. If the signal exceeds the maximum capability then
appears on the front panel and the appropriate bit is set in the device status
OVERLOAD
registers.
FILT_ON / FILT_OFF
inserts a hardware analog filter into the measurement signal path.
FILT_ON
SPOT? phs
Recall of Spot Frequency
OHMS phs
Normal OHMS
Remote Operations Using the IEEE 488 Interface
Syntax Diagrams of Major 8508A Functions
1
2
3
4
5
6
function and set its
OHMS
,
Nrf
A UTO
FILT_ON
FILT_OFF
RESL5
RESL6
RESL7
RESL8
FA ST_ON
FA ST_OFF
TWO_WR
FOUR_WR
LOI_ON
LOI_OFF
adj211f.eps
adj212f.eps
RANGE
4
4-13