Setting The Scsi Id; To Set The Scanner's Scsi Id - Ricoh IS450DE Operator's Manual

SETTING UP THE SCANNER
Each device in a SCSI chain must have its own unique ID. Use the procedure
below to set the scanner's SCSI ID.
Note the following important points when setting the scanner's SCSI ID.
No two devices in the SCSI chain can have the same SCSI ID.
You can change the scanner's SCSI ID while power is on, but the new setting
does not take effect until you reset the scanner.
Never set 8 or 9 as the scanner's SCSI ID. Though 8 and 9 settings are
available, you should use IDs 0 through 7 only.

To set the scanner's SCSI ID

1
Turn the rotary switch on the
back of the scanner until the
SCSI ID number you want to use
is visible.
2
If the scanner is on when you
change the SCSI ID, reset it by
turning power off and then back
on again.
Note: Whenever there are two these scanners connected in the same
SCSI chain, be sure to set SW1 of one of the scanner's DIP
switches to ON.
1-8

SETTING THE SCSI ID