Using Two Scanners In The Same Scsi Chain; Without Scam Adapter; With Scam Adapter; To Change The Setting Of Dip Switch 1 - Ricoh IS450DE Operator's Manual

USING TWO SCANNERS IN THE SAME
Two of these scanners can be included in the same SCSI chain. In such a
case, you must make sure to correctly make certain settings in order to avoid
conflicts in the chain. The settings you should make depends on whether or not
the computer you care connected to is equipped with a SCAM adapter.

Without SCAM Adapter

In this case, just make sure that each scanner has its own unique SCSI ID.
No other setting is required.

With SCAM Adapter

When the computer you are connecting to is equipped with a SCAM adapter, you
must assign each scanner a unique SCSI ID and also change the setting of DIP
switch 1 for one of the scanners to further protect against data communication
conflict.
DIP switch 1 of one of the scanners must be OFF (default setting).
DIP switch 1 of the other scanner must be ON.

To change the setting of DIP switch 1

1
Change the position of DIP
switch1 on the back of the
scanner to ON.
2
Turn power off and then back on
again.
SETTING UP THE SCANNER
SCSI CHAIN
1-9