Left And Right Side Cover Removal - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

LEFT AND RIGHT SIDE COVER REMOVAL

Preparation:

Remove the Maintenance Cover as described in
Removal on page 58.

Remove the Top Cover as described in
1. Remove the left and right Joint Covers, as shown in
2. Remove the seven screws (five silver CP(W2) M4x12 and two black
CP(W2) M4x12) securing the Left Side Cover, and remove the Left Side
Cover. Repeat for the Right Side Cover.
NOTE: The control panel is attached to the Right Side Cover. When
removing the Right Side Cover, detach the flat cable from the
control panel.
Figure 4-6. L/R Side Cover Inner Screw Location
Disassembly & Assembly
Maintenance Cover
Top Cover Removal on page 59.
Figure 4-7.
CP (W2) M4x12 silver screws
Right Side
Cover
CP (W2) M4x12 black screws
Figure 4-7. L/R Side Cover Outer Screw Location
CP (W2) M4x12
silver screws
Joint Cover
60